Cyclone Mooring Pendant

Cyclone Mooring Pendant  
View Larger Image

Product Description:
Made from our STS-12 rope which uses the latest Dyneema fiber, resulting in a rope that is of extremely high tensile strength and ultra low elongation.

Features:

  • Floats
  • Excellent Strength-to-Size Ratio
  • Excellent Wet/Dry Strength Retention
  • Marine Tech Coated to Improve Abrasion Resistance

Applications:

  • Mooring Pendants

Colors Available:

  • Black

Lengths Available:

  • 600'

SizeWeightTensile
lbs/100'g/mlbskg
 1/2" (12mm) 6.2 92.2 34,300 15,591
 5/8" (16mm) 10.1 150.3 58,000 26,364
 3/4" (18mm) 13.8 205.3 69,000 31,364
 7/8" (22mm) 18.8 279.7 97,500 44,318
 1" (24mm) 21.4 318.4 115,900 52,682

Sunlight/UV:
Dyneema Fiber has very little degradation from UV and can be used over long term if inspected regularly.

Chemicals:
Dyneema Fiber has good resistance to most minerals, organics, acids, and weak alkalis. Dyneema Fiber also has excellent resistance to bleaches and other oxidizing agents as well as to most solvents.

Heat:
Dyneema SK75 fiber has a melting point of 300 degree Fahrenheit with progressive strength loss above temperatures of 150 degrees Fahrenheit

Dielectrics:
Good resistance to the passage of electrical current. However, dirt, surface contaminants, water entrapment, and the like can significantly affect dielectric properties. Extreme caution should be exercised any time a rope is in the proximity of live circuits.

Sheaves:
Recommended sheave diameter to rope diameter is 8:1.

Working Loads:
No blanket safe working load (SWL) recommendations can be made for any line because SWL's must be calculated based on application, conditions of use, and potential danger to personnel among other considerations. It is recommended that the end user establish working loads and safety factors based on best practices established by the end user's industry; by professional judgment and personal experience; and after thorough assessment of all risks. The SWL is a guideline for the use of a rope in good condition for non-critical applications and should be reduced where life, limb, or valuable property is involved, or in cases of exceptional service such as shock loading, sustained loading, severe vibration, etc. The Cordage Institute specifies that the SWL of a rope shall be determined by dividing the Minimum Tensile Strength of the rope by a safety factor. The safety factor ranges from 5 to 12 for non-critical uses and is typically set at 15 for life lines.

Splicing Instructions:
12-Strand Eye Splice - Brummel

Product Datasheet
pdf image
Product Information (pdf file)


Copyright © 2008 New England Ropes, Corp. All rights reserved