DynaGlide Throw Line

DynaGlide Throw Line  
View Larger Image

Product Description:
Highly visible snag free throwline made from 100% HMPE (High Modulus Polyethylene) that is pre-stretched and tensile-set then treated with a urethane coating. Compact design glides easily over branches allowing lighter throw weights.

Features:

  • Very high strength
  • Very low stretch
  • Coating improves abrasion resistance and provides color coding capabilities
  • Slick finish glides effortlessly over bark

Applications:

  • Throw line

Colors Available:

  • Orange
  • Green

Lengths Available:

  • 2400'

SizeWeightTensile
lbs/100'g/mlbskg
 3/32" (2mm) 0.2 3.0 1,000 454

Sunlight/UV:
Very little degradation from sunlight. Can be used outside over long term if inspected regularly.

Chemicals:
HMPE has good resistance to most minerals, organics, acids, and weak alkalines. HMPE also has excellent resistance to bleaches and other oxidizing agents and to most solvents.

Heat:
HMPE melts at 300°F with progressive strength loss above 150°F.

Dielectrics:
Good resistance to the passage of electrical current. However, dirt, surface contaminants, water entrapment, and the like can significantly affect dielectric properties. Extreme caution should be exercised any time a rope is in the proximity of live circuits.

Sheaves:
N/A

Working Loads:
No blanket safe working load (SWL) recommendations can be made for any line because SWL's must be calculated based on application, conditions of use, and potential danger to personnel among other considerations. It is recommended that the end user establish working loads and safety factors based on best practices established by the end user's industry; by professional judgment and personal experience; and after thorough assessment of all risks. The SWL is a guideline for the use of a rope in good condition for non-critical applications and should be reduced where life, limb, or valuable property is involved, or in cases of exceptional service such as shock loading, sustained loading, severe vibration, etc. The Cordage Institute specifies that the SWL of a rope shall be determined by dividing the Minimum Tensile Strength of the rope by a safety factor. The safety factor ranges from 5 to 12 for non-critical uses and is typically set at 15 for life lines.

Splicing Instructions:
12-Strand Eye Splice - Brummel

Product Datasheet
pdf image
Product Information (pdf file)